BP-8 ValveSection - 5 Appendix
Section 5 - Appendix
Reinitializing the BP-8 Valve
This option allows you to restore the contents of the BP-8 ValveOs memory to the original factory condition and calibrate the expression pedal.
WARNING: Performing this function will destroy all user-programmed data. All such data will be lost forever!
To restore the factory Programs and calibrate the expression pedal, the procedure is as follows:
1. Plug in the BP-8 Valve while holding down the Parameter Select <UP> button.
2. When rSt appears in the display window, release the Parameter <UP> button and press the Value <UP> button. The BP-8 will reset
to factory condition.
3. The display will now prompt you to re-calibrate the expression pedal by reading: PEDL CAL
4. When the display reads: toe dn , rock the pedal forward and press any one of the flashing footswitches.
5. When the display reads: toe up , rock the pedal back and press any one of the flashing footswitches. The expression pedal will now
be calibrated and the BP-8 will return to program mode.
Re-calibrating the Expression Pedal
If the Expression Pedal calibration should fail, you can re-calibrate it by disconnecting the power, press and hold the parameter select
<DOWN> button and re-apply power. Release the button and repeat steps 3-5 as shown in the ORe-initializing the BP-8 O section above.
User Guide21 |