Effects and Parameters
Equalization helps shape the tonal response of your guitar signal. The EQ in the GNX3 is similar to the
tone knobs on an amplifier with the exception that the GNX3 lets you choose the center frequency for
the Mid Range and Treble adjustments.
EQ Green/Red - The STATUS button adjusts the EQ when a Warped combination (green and red) of
amps is selected. This button does not function if only the green or red channel is
selected.
Bass Level - The Parameter 1 knob adjusts the amount of low end enhancement. Ranges from Grn/Red
BASS-12 to 12 (dB).
Mid Frequency - The Parameter 2 knob selects the frequency that the boost is applied by the Mid Level
knob. Ranges from 300Hz to 5000Hz.
Mid Level - The Parameter 3 knob adjusts the amount of mid range enhancement. Ranges from
Grn/Red MID-12 to 12 (dB).
Treble Frequency - The Parameter 4 knob selects the frequency that the boost is applied to by the
Treble Level knob. Ranges from 500Hz to 8000Hz.
Treble Level - The Parameter 5 knob adjusts the amount of high end enhancement. Ranges from
Grn/Red TRBL-12 to 12 (dB).
Noise Gate
A Noise Gate is designed to eliminate hiss and ambient noise while you are not playing. A Noise Gate
can also be used to create an automatic swell in volume. The GNX3 includes two different types of
Noise Gates: Silencera, and Pluck.The Silencera operates as a standard Noise Gate.The Pluck Noise
Gate is designed to close after every note (depending on the Pluck Sensitivity).This allows automatic
volume swells to occur on a note by note basis.
Gate On/Off - The STATUS button turns the Noise Gate (gate) on and off.
Gate Type - The Parameter 1 knob selects between the Silencera (Silencer) or Pluck (PLUCK) type
of Noise Gates.
Gate Threshold - The Parameter 2 knob sets the signal strength required to open or close the Noise
Gate. The Gate Threshold (THRESHld) parameter ranges from 0 (opens easily) to
40 (requires strong signals to open).
Gate Attack - The Parameter 3 knob adjusts the length of time it takes the gate to open (ATTACK) and
the signal to become audible once the Threshold has been exceeded. Ranges from 0
(immediate signal), to 9 (This setting will gradually ramp up the volume).
* Pluck Sensitivity - Selects the threshold (PLUCK) where the Gate re-triggers when using the Pluck
type Noise Gate. This parameter is only available when Pluck is the selected type
of Noise Gate. Ranges from 0 (requires strong signals) to 99 (re-triggers with
weak signals).
The Parameter 5 knob does not function when the Noise Gate is selected.
* These Parameters are only available using the GENEDITacomputer editor software.
Chorus/Mod Effects
The Modulation Effects group is a multi-function module allowing you to select effects such as; Chorus,
Flanger, Phaser,Triggered Flanger,Triggered Phaser,Tremolo, Panner,Vibrato, Rotary Speaker,AutoYaa,
YaYaa, SynthTalka, Envelope Filter (auto wah), Detune, and Pitch Shift. Only one of the effects in this
row can be used at a time. When the Chorus/Mod group is selected, the STATUS button is used to
turn the Effect (effect) module on and off. The Parameter 1 knob is used to select the type of effect.
After selecting the type of effect in this module, the Parameter 2-5 knobs can then be used to adjust the
individual parameters associated with the selected effect. The following pages describe each effect and
their parameters in more detail.
Chorus
23 |
ACEC
